The Government recommends that everyone insulates their lofts to a depth of 270mm if they use rolls of mineral wool insulation
But homeowners also want to use the loft for storage, and so many people put boxes on top of the insulation or, even worse, put boards down on top of the joists. In both cases, the insulation gets compressed and squashed insulation doesn't perform very well!
- Ceiling joists are only 75mm or 100mm high therefore if you have 270mm of insulation, it has to sit well above the level of the joists, making it impossible to see them.
- When you can't see the joists, it becomes difficult to move around safely inside the loft and risk falling through the ceiling.
- Almost all lofts are accessed for either maintenance or storage and almost always results in reduced insulation effectiveness because it is squashed by boards at joist height, or simply because people refuse to insulate up to 270mm in the first place.
Therefore, for insulation to work, a system is needed to protect the insulation whilst also providing a stable platform for safe access to the loft as they do not want to lose storage space.
The Solution – StoreFloor from LoftZone
- The LoftZone StoreFloor protects the insulation underneath it, and provides a safe deck for access or storage
- Using a raised adjustable beam that goes across the joists it allows for variations in joist spacing but also works precisely with standard 1,220mm loft boards and standard 600mm wide insulation rolls
- The resulting system is extremely strong, easily passing the British Standard 6399-1:1996 for minimum imposed floor load requirements.
It is also possible to install StoreFloor without emptying the loft space by clearing a small area (1.2m x 1.2m) and start building a raised loft floor there. Boxes, etc can then be moved to this area so clearing the next space
Manufacture of this revolutionary British-designed loft storage solution has started in the Midlands.
For their part Rutland Plastics started production of the plastic beam support for the ‘StoreFloor’ earlier this month.
LoftZone chose Rutland Plastics to help with this project because of the technical advice they could offer. The beam support needed to be strong to withstand storage and a person walking on the raised floor.
Rutland Plastics used Visiflow mould flow analysis to help with the design of the mould tool to ensure that weld lines did not occur at any points of maximum stress in the moulding.
Neil Smith and Hayley Bull of Oakham recently had StoreFloor installed in their home. Neil said “With heating bills ever increasing, I wanted to properly insulate my loft but also keep it for storage. The StoreFloor is a superb idea that does just what I need.”
Dave Raval, chief executive of LoftZone, said: “StoreFloor will revolutionise lofts, providing one of the biggest ever incentives to improve the uptake of loft insulation, at only a small additional cost, and at the same time increasing the effectiveness of insulation.”
Stuart Lovett, marketing manager of Rutland Plastics, added: “We are proud to be working with LoftZone on this innovative approach to providing additional storage without compromising on insulation.”