Series 4 Ltd

HOTweezers  represent the state of the art in the design and construction of thermal wire strippers.

Hotweezers thermal wire strippers weigh less than 57g including cable and connector, making it an ideal hand-held solution with smooth and efficient operation. The heater filaments are completely sealed in the stripping head of a Hotweezers thermal wire stripper device enhancing its performance consistently.

Advantages of using HOTweezers:

1. The filament is resistant to oxidation.

2. The stripping head will not distort nor lose alignment as is the case with ordinary hot wire strippers.

3. Since the filaments are enclosed, a greater portion of the heat generated is retained to do useful work. Consequently the power supply can be much smaller than usual, and the current consumption is drastically reduced. The M-10 power supply consumes a mere 20 watts at the highest temperature setting.

4. Wire holes can be ground into the stripping head without damage to the filaments. With wire holes, the rotation of the stripper required to accomplish a strip is reduced from 180o to 15o and mashing of conductors, especially the finer gauges, is completely eliminated.

5. Because the filaments are an integral part of the stripper body, no maintenance is required.

Three different models of the HOTweezers are available to satisfy most stripping requirements. For precise insulation removal Models 4A and 4B have stripping holes to yield a clean, even strip free of insulation "tails" and to prevent mashing of the conductor strands. Model 4C is designed for use on cable jackets and larger diameter conductors. Maximum cable or conductor O.D. that can be stripped is 0.25 inch (6.35 mm) and maximum insulation wall thickness is .05 inch (1.27 mm). For stripping requirements that exceed these dimensions the HOTnife can be used. All models have the new strip length gauge so that repetitive stripping operations can be done accurately. The gauge is easy to adjust without a screwdriver or special tools. The standard power cord for all three models is a flexible, lightweight cable with a high temperature silicone rubber jacket that resists burns.

If you have a requirement that may require a special model, please contact us directly.

Image shows tweezer with power supply.

Showing 2 of 74 Products
  1. Component Counter

    Component Counter
    The county is a microcomputer based instrument which counts radial and axial components on tape. The County component counter counts both right or left. It is equipped with a divider from 1 - 10, a totalizer mode, counting or preset mode, plus an alarm that goes off when the desired component number has been reached. Attachments are also available to convert the unit to SMD component use.
  2. SMD Component Counter

    SMD Component Counter
    The County S is a motorized counter for SMD component counting. This machine works in a simple way by counting the holes on the tape.All functions are easy to operate by the help of interactive messages on the display, while system status is monitored by means of LED's near the command keys. The memory function allows partial counting for the same component type and memory recall can show at any time the memory contents without loss of the actual counting data.