Anglo Carbon was founded in 1959 and is at the forefront of carbon and graphite technology, achieved by being alert and responsive to the constant evolution of our customers' needs.
Our products range from carbon brushes, contacts and collectors for electrical applications, to mechanical uses such as compressor vanes, bearings, bushes and seals.
To compliment our electrical carbon products, we can also offer brush holders, slip rings, braided cable straps and commutator maintenance equipment.
Our aim is towards total customer satisfaction. A 24/48 hour breakdown service is available on request.
Anglo Carbon will design, manufacture and supply grades specifically adapted to your application(s) criteria.
Anglo Carbon manufacture all brushes in the UK, and offer ex-stock delivery to meet both OEM and aftermarket requirements. Our flexible production techniques allow for a rapid response, from high volumes to even small batch production runs where special designs are required.
Carbon Contacts and Linear Collectors
Hard carbon and copper contacts and collectors are readily available. The types commonly offered include half round patterns for drum controllers and certain linear collectors from our standard range. Non-standard linear collectors, both open and protected system inserts as well as copper or carbon contacts can also be manufactured to your specification within very short lead times, or moulded for higher volumes.
For information on products which aren't available through our online catalogue, please contact us.
Flexible Braided Earthing Straps
We stock a broad range of round braided flex, and terminals both in plain copper and tin plated, from which we can produce highly flexible earthing connectors. These are commonly used in switchgear, and a range of industries.
Earthing straps can also be supplied with a range of insulating sleeves, including colour coded heat shrink insulation.
Flat braided assemblies are also available on request, either as a single piece, or multiple straps.
For information on products which aren't available through our online catalogue, please contact us .
The selection of a carbon brush grade can significantly influence the performance and life of a motor. Drawing on over 44 years experience in supplying carbon brushes for industrial applications, covering a wide range of industries, Anglo Carbon has over 100 different grades of carbon, and the applications knowledge to satisfy your requirements - whether you are repairing or maintaining motors, or are a motor manufacturer.
Anglo Carbon manufacture brushes for micro-motors in a range of materials from copper to silver graphites, for use in the following applications;
Please visit our website for more information.
Our carbon/graphite bearings are used predominantly in high temperature applications, for example in ovens, or in food processing plants where lubricated bearings cannot be used due to the risk of contamination. We also manufacture bearings for submersible and centrifugal pumps, where carbon/graphite's resistance to most liquids being handled can offer considerable performance and wear rate advantages.
To complement our industrial carbon brush range, we can also supply commutator maintenance equipment. It is a prerequisite for performance that the commutator is cleaned, and that the brushes are properly bedded in before the motor is run at full speed.
We supply, on an ex-stock basis, glass fibre commutator cleaning sticks and commutator stones used for bedding in carbon brushes.
We can supply graphite anodes, predominantly used for metal reclamation in wide range of sizes and designs, ranging from a set to high volume annual contracts on a call off basis if required.
Anglo Carbon manufactures a range of crucibles, primarily used in thin film deposition processes, for both electronic and optical applications. Our components have proved to be particularly successful when used for precious metals and aluminium, where the strength, heat resistance and low coefficient of thermal expansion, have lead to increased evaporation rates and a longer service life than many graphite crucibles on the market.
We can also manufacture graphite moulds for diamond tooling and castings of precious metal bars to customer specifications.
In addition to moulds, crucibles and anodes, a diverse range of components are available to customer specifications predominantly for use in the aluminium and glass industries, such as furnace furniture, carbon ‘plugs’, bearings, plates, guides, dies and funnels.
|Anglo Carbon||Tel:||(+44) 0113 2564664|
|Waterloo Mills||Fax:||(+44) 0113 2571119|
Don't forget to mention you found us on the Applegate directory!