Metsec’s Purlin Division is the UK’s largest designer and manufacturer of light gauge galvanised Steel Purlins,Side Rails and Mezzanine Floor systems for use in a wide range of industrial and commercial developments.
We offer all the different types of Purlins including Z, C and mezzanine floor sections. These are designed so that they are able to give the best levels of structural performance in a roof, wall and mezzanine floor
Metsec Cable Management manufactures cable containment and support systems for the mechanical and electrical services industry.
All are complete systems with simple accessories, offering flexible design solutions and the rapid installation system. A prefabrication service is also available for major contracts, bringing significant time and cost savings for M & E contractors.
Metsec offer a complete cable ladder system ranging from 50mm deep light duty ladders to 150mm deep extra heavy duty ladders in UK and European widths, up to 900mm, with a wide range of accessories.
Metsec cable ladders generally conform to BS EN 61537:2007 "cable management - cable tray systems and cable ladder systems" and are fully supported by independent testing at the Department of Mechanical Engineering at the University of Strathclyde
Metsec offer complete cable tray systems from 12mm to 50mm deep and 50mm to 900mm wide, all with a wide range of accessories.
Materials and finishes available are mild steel pre galvanised as standard with mild steel hot dip galvanisedafter manufacture and stainless steel grade 1.4404 (316L) to order.
Standard distribution trunking is available in widths and depths up to 225mm as standard. Lids are attached by turnbuckle fixings, with Screwfix and tamperproof fixings also available
Lighting trunking is available in 50mm x 50mm with straights in various length configurations. This range utilises the Standard distribution trunking components but with snap on lids available in pre galvanised steel or white plastic. This allows flexibility on site when using both systems
Four channel profiles are available as plain back or slotted back variants and each can be assembled into multiple configurations when additional load carrying capacity is needed.
This is further complimented with a wide range of brackets and fasteners to achieve almost any framework assembly and configuration.