AN Wallis and Co Ltd
The Number One Supplier For All Your Surge Protection, Earthing And Lightning Needs
TOTAL SYSTEM PROTECTION
Lightning Transient Overvoltage Protection for Mains Power
All mains power lines entering or leaving the building are prime routes for lightning and switching induced surges and overvoltages to enter the electrical and electronic systems. Due to the large cross sectional area of these cables high current and voltage surges can enter with minimal attenuation.
By fitting Wallis Surge Protection devices in parallel with the incoming mains, surges and overvoltages can be reduced to an acceptable level. Protection devices are available for single and three phase as well as three phase split busbar systems.
The Number One Supplier For All Your Earthing and Lightning Protection Needs
EARTHING & EQUIPOTENTIAL BONDING | EXTERNAL STRUCTURAL PROTECTION |
|
|
|
|
|
|
|
|
|
|
|
|
|
Filter products and services
-
Air Rod Cable Saddles
These saddles are used to support the copper taper pointed air rods on flat roof surfaces.Request a Quote Supplied by AN Wallis and Co Ltd -
Air Rod Ridge Saddles
Ridge Saddles are used to support air rods on roof ridges.Request a Quote Supplied by AN Wallis and Co Ltd -
Air Rods
These air rods are used as part of the lightning protection system. They are manufactured from 10mm diameter rod and are supplied with a locknut.Request a Quote Supplied by AN Wallis and Co Ltd -
Flat Air Rod Saddles
Flat saddles are used to support air rods on flat roof surfaces.Request a Quote Supplied by AN Wallis and Co Ltd -
Light Duty Air Rod Saddles
Light Duty Saddles are used to support air rods on flat roof surfaces.Request a Quote Supplied by AN Wallis and Co Ltd -
Multi-Point
Used in conjunction with the taper pointed copper air rods.Request a Quote Supplied by AN Wallis and Co Ltd -
Multi-Purpose Air Rod Saddles
These saddles can be installed horizontally on roofs or vertically on walls or parapets. The saddles are suitable for use with 8mm diameter solid circular conductor as well as 25 x 3mm flat tape.Request a Quote Supplied by AN Wallis and Co Ltd -
Side Mounting Air Rod Brackets
These brackets provide a 75mm projection from the building face and are used where it is not possible to fit a saddle onto the building roof. The brackets are used in conjunction with the rod to tape coupling used to secure the flat tape to the air rod.Request a Quote Supplied by AN Wallis and Co Ltd -
Taper Pointed Air Rods
Air rods form an important part of the air termination network of a lightning protection system. All of our air rods are supplied with a locknut enabling the rod to be locked tight against the conductor. We sell both copper and aluminium air rods.Request a Quote Supplied by AN Wallis and Co Ltd